TR7 & TR8 Mailing List

Has anyone on this list installed a TR7 cylinder head using ARP

0 Members and 1 Guest are viewing this topic.

Sujit Roy

I'm installing a head on a Stag using an ARP cylinder head kit for a

TR7.Someone on the Stag list mentioned if using the provided lube, that the

clamping load should be reduced by about 15% from what the Stags ROM says.

The Stag ROM says to install studs and bolts dry and to clamp everything

down to about 55 lbs / inch Anyone agree with this?

Also, they mentioned since the clamping load is different because the studs

go in at an angle to the head and are not perpendicular, The bolts should

be torqued down less than mentioned in the ROM.

Any thoughts?



Sujit Roy

Cupertino, California



Archives provided courtesy